The paintwork of the car body is not only beauty and aesthetics, but also protection. A dense, uniform, undamaged paint layer reliably protects bodywork from premature rusting and destruction of the vehicle.
Therefore, if the paintwork is partially damaged, you should definitely contact the service station in Kiev for abrasive polishing.
The principle of abrasive polishing at a service station in Kiev
The procedure is a treatment of the surface of the car body with a special abrasive paste. The master, literally, mechanically removes a thin layer of protective varnish. Thus, the varnish covering the paint becomes thinner. It is possible to remove small scratches and defects, leveling the overall surface. Of course, the protective paintwork becomes thinner, but it is perfectly even.
Sometimes not the entire body is polished, but only a part of it, which is noticeably damaged.
Tools
The workshop of specialists must have:
- polishing machine.
- Nozzles.
- Paste with abrasive substances.
- Soft, lint-free cloth.
- Polish based on wax or silicone.
Please note that it is impossible to perform such a procedure with your own hands. It is carried out exclusively at the service station in Kiev by masters who are fluent in this technique. Without a polishing machine and special skills, it will not be possible to restore the coating. Even with great effort.
Body preparation
The vehicle is cleaned of dirt and dust, dried before the polishing procedure at the service station in Kiev. Masters additionally protect the windows of the vehicle so that the paste does not get on them.
Carrying out the procedure
Polishing is carried out in several successive steps. The master visually divides the body into several sections and begins to polish them sequentially. First, the roof is polished, then the hood, after the trunk, and so on.
Professional polishing occurs, as mentioned above, using a special abrasive paste. After the processing procedure, the service station master in Kiev waits a few minutes until the paste reacts with the paintwork. Then a polishing machine is used. At the end of the treatment, the car is blown with a stream of compressed air from the dried paste.
At the end of polishing at the service station in Kiev, the car is washed again, the protective coating is removed from the windows. The procedure is considered completed. The car body looks great.
